A : For small PV modules, standard in-line frame gluing machines are inconvenient to operate. Instead, you can use our company's custom-designed frame gluing machine; it features user-friendly, "foolproof" operation and requires virtually no adjustment when switching between models, making it simple and convenient.

A : For irregularly shaped PV modules where frames do not conform to standard shapes or specifications, ordinary gluing machines are unsuitable. You can use our Model 05 frame gluing machine, which is simple, convenient, and saves labor and adhesive.

A : The nozzles on the custom PV frame gluing machine can be micro-adjusted vertically and horizontally as needed. They can apply adhesive to the bottom of the groove without overflow, allow for overflow on the back, or—for frames with a front-facing overflow channel—ensure the channel fills with adhesive without any spilling onto the front surface.

A : During assembly, the laminated module is held perfectly flat by suction cups at the frame insertion station. The long frame sections are placed on precisely adjusted plastic plates and clamped down by pneumatic cylinders; this setup ensures that, as the frame moves, the adhesive overflows uniformly onto the back.

A : Applying adhesive only to the outer perimeter without filling the inner groove secures the frame to the laminated module but leaves the cross-section of the laminate unsealed. Over time, water ingress can occur, leading to issues like short circuits and significantly reduced service life. Since this does not meet standard PV panel manufacturing protocols, this method should not be used.

A : The custom solar PV module assembly line can handle modules with a width greater than 50 cm and a length greater than 70 cm. It can be customized to meet specific client requirements and is capable of assembling extra-large modules.